Free Estimate Call Now
Custom tile shower with a corner bench in a master bathroom
  • Morganton Based

    Serving Morganton, Valdese, Marion, Lake James, Lake Rhodhiss and the surrounding areas.

  • Free Estimates

    Three generations of masonry craftsmanship. Call or text (828) 390-8226.

Tile Showers & Backsplashes

We tile showers, bathroom floors and kitchen backsplashes, from one backsplash to a whole bathroom. Most of what decides a tile job is under the tile: the board behind it, the waterproofing, the slope of a shower floor and how flat and stiff the floor is. Those are the parts we spend the time on, because they decide whether the tile stays tight and the wall behind it stays dry. In Burke County the median home was built in 1980 (US Census ACS 2024 5-year), so a bathroom here may still have its first tile, the board it was set on and a floor with more than 40 years of use under it.

Custom tile shower with a corner bench in a master bathroom

Tile Shower Installation, Step by Step

Tub insert with a white tile surround and a window above, in a half bath

A tile shower is a waterproof box with tile on its face. Tile and grout are not waterproof on their own: water soaks through grout, so the layers under it have to keep the water in the shower. The steps:

  • Tear-out. The old tile, board and pan come out to the studs and the subfloor. Wet or soft framing shows up then and is fixed before anything new goes on.
  • Valve and drain. Your plumber sets the shower valve and the drain before the walls close. That part is the plumber's, done before ours.
  • Board. Cement board or foam board goes on the walls, screwed to the studs, with its seams taped.
  • Sloped floor. The shower floor is a mortar bed sloped to the drain, or a pre-sloped pan, so water runs off instead of sitting under the tile.
  • Waterproofing. A waterproofing membrane covers the whole wet area: walls, floor, bench and niche, lapped at the seams and corners and tied into the drain.
  • Layout and setting. Each wall is laid out from its center, so the cut pieces at both corners match, and the tile is set in thinset with spacers holding the joints even.
  • Grout and seal. The joints are grouted, the inside corners and the joint at the floor get a flexible sealant instead of grout, and the grout is sealed once it cures.

Shower Benches, Tub Surrounds and Bathroom Floors

On a pair of bathroom renovations we finished, the main bathroom got a complete tile shower with a bench and a marble tile floor, and the half bath got a tub insert with tile around it and a wood-look tile floor. Each part of that has its own rules:

  • Bench. A built-in bench is framed or built up in block or board, sloped slightly toward the shower so water runs off the seat, and waterproofed with the rest of the shower before it is tiled.
  • Marble. Natural stone is porous, so marble tile is sealed, and it is set in white thinset so nothing dark shadows through a light stone.
  • Tub surround. Around a tub insert the board laps over the tub's flange, so water running down the wall lands in the tub. The joint where the tile meets the tub is sealed with a flexible sealant, not grout.
  • Wood-look tile. Plank tiles are laid in an offset pattern like wood boards. Long tiles are rarely dead flat, so the offset is kept to about a third of the plank's length rather than half, which keeps the edges level with each other.

Any tile floor needs a flat, stiff subfloor. A floor that flexes cracks grout and tile, so a soft floor is stiffened and an uneven one is leveled before tiling. Large tiles show lippage, one edge standing proud of the next, so the bigger the tile, the flatter the floor has to be, and leveling clips hold the edges even while the thinset sets.

Kitchen Backsplash Installation

Herringbone tile backsplash in a kitchen with gray cabinets

A backsplash is the tile on the wall between the countertop and the upper cabinets, and in many kitchens around the windows and doors too. On one kitchen we laid a herringbone backsplash and carried it through the whole room: around the cabinets, along the countertops and around the windows and doorways, so the tile ends at a clean edge everywhere instead of stopping short.

Herringbone is a zigzag of rectangles set at right angles to each other, and it is unforgiving: one piece off at the start shows across the whole wall. So the layout starts from a center line, usually on the range or the sink, and the lines are snapped in chalk before the first tile goes up. Almost every edge is a cut, at the countertop, the cabinets and the window trim. Each outlet gets a notched cut so its cover plate sits tight, and where the tile stops on an open edge, a finished edge piece or a trim strip closes it.

A backsplash goes on drywall that is sound and flat. Where old tile comes off and takes the drywall's face with it, the wall is patched or new board goes up first.

Porcelain, Ceramic or Marble Tile

  • Porcelain is dense and takes on very little water, so it suits shower floors and walls and the wood-look planks. It is hard, which makes it slower to cut.
  • Ceramic is softer and easier to cut, and common on walls and backsplashes.
  • Marble and other natural stone need sealing and gentle cleaners, and the pieces vary from one to the next, so they are laid out dry and mixed before setting.
  • Size and pattern. Small tiles and mosaics follow the slope of a shower floor and give more grout lines for grip; large tiles mean fewer grout lines but need a flatter base. Herringbone and other patterns take more cuts than a straight lay.

What Decides the Cost of Tile Work

A tile job is priced from the room. What decides the cost of a tile shower, a floor or a backsplash:

  • Square feet of wall and floor to tile.
  • Tile size and pattern. Herringbone and mosaics take more cutting than a straight lay of larger tile.
  • A bench or a niche, each built and waterproofed before it is tiled.
  • Waterproofing and board: how much of the room is a wet area.
  • Old tile to tear out, and what is found under it.
  • Marble or porcelain: natural stone takes more care to set and needs sealing.

We tile bathrooms and kitchens in Morganton, Hickory and the towns around them. A tile shower is often one part of a bigger bathroom job, and our remodels page covers the rest of it. For stone around a fireplace, see stone fireplaces. Call or text (828) 390-8226 for a free estimate.

Ready for a New Tile Shower or Backsplash?

Call (828) 390-8226 for a free estimate.

Get a Free Estimate

Frequently Asked Questions

Questions We Hear a Lot

Kitchen with gray cabinets, a butcher block counter and the herringbone backsplash
  • It depends on the shower: its size, the tile and the pattern, a bench or a niche, the waterproofing, tearing out the old shower and whether the tile is marble or porcelain. We look at the bathroom and give you a figure in a free estimate. Call or text (828) 390-8226.

  • It depends on the square feet of wall, the tile and the pattern, how many outlets, windows and open edges the tile has to be cut around, and whether an old backsplash comes off first. Herringbone takes more cuts than a straight lay. We give you a figure in a free estimate.

  • No. Tile is close to it, but grout lets water through, so the waterproofing goes under the tile: a membrane over cement board or foam board, and a floor sloped to the drain. That layer, not the tile, keeps water out of the walls and the floor.

  • Small tiles and mosaics follow the slope to the drain and give more grout lines for grip. Porcelain takes on very little water; marble works too but needs sealing. Larger tiles suit a floor that slopes one way, such as one with a long linear drain.

  • Yes. Plank tile is laid in an offset pattern like boards, with the offset kept to about a third of the plank's length so slightly bowed tiles stay level with each other. The subfloor has to be flat and stiff first, or the grout cracks.

  • Yes. We offer free estimates. Call (828) 390-8226, send us a message on Facebook or use the contact form.

  • We serve Morganton, NC and the surrounding areas. Recent jobs include Lake James, Lake Rhodhiss, Valdese and Marion. Call (828) 390-8226 to check your location.

Contact Us

Ready to Get Started?

Call or text Chase Masonry at (828) 390-8226 for a free estimate.

Get a Free Estimate